+- PULP Community (https://pulp-platform.org/community)
+-- Forum: PULP's Community forum (https://pulp-platform.org/community/forumdisplay.php?fid=1)
+--- Forum: PULP General questions (https://pulp-platform.org/community/forumdisplay.php?fid=2)
+--- Thread: Error run ./cmake_configure.riscv.gcc.sh (/showthread.php?tid=297)
Error run ./cmake_configure.riscv.gcc.sh - Ali77124 - 08-25-2022
Hello, good time!
I'm going to run PULPino and i used ri5cy_gnu_toolchain for this.
But when using the ./cmake_configure.riscv.gcc.sh command, I get the following error:
C compiler identification is unknown
System unknown to cmake, create:
Platform/Linux-CXX To use this system, please send your configuration file to cmake@www.cmake.org so it can be added to cmake.
Your CMakeCache.txt file was copied to CopyOfCMakeCache.txt. Please send that file to cmake@www.cmake.org.
CMake error in CMakeLists.txt:20 (enable_language):
No CMAKE_C_COMPILER found.
Tell CMake where to find the compiler by setting the environment
"CC" variable or CMake cache entry CMAKE_C_COMPILER to full path to
Compiler or named Compiler if it is in PATH.
The configuration is incomplete, errors have occurred!
See also "/home/ali/pulpino/sw/build/CMakeFiles/CMakeOutput.log".
See also "/home/ali/pulpino/sw/build/CMakeFiles/CMakeError.log".
Also, the PATH variable related to ri5cy as below in the bashrc file. I added:
export PATH=/home/ri5cy_gnu_toolchain/install/bin:$PATH
Thanks in advance for your help!