+- PULP Community (https://pulp-platform.org/community)
+-- Forum: PULP's Community forum (https://pulp-platform.org/community/forumdisplay.php?fid=1)
+--- Forum: PULP General questions (https://pulp-platform.org/community/forumdisplay.php?fid=2)
+--- Thread: Compiling and running CNNs on FPGA(pulp) (/showthread.php?tid=338)
Compiling and running CNNs on FPGA(pulp) - NEO - 04-04-2024
Hi, Is it possible to compile and run CNNs on FPGA (pulp)? If so, could you direct me to a guide or tutorial on how to achieve this? This information is crucial for my work.
RE: Compiling and running CNNs on FPGA(pulp) - AlessioBurrello - 04-05-2024
There is no direct guide to compile CNNs for FPGA. On the other hand, if you are able to run generic C codes in FPGA, then you can compile the same codes generated for the chip.
RE: Compiling and running CNNs on FPGA(pulp) - NEO - 04-11-2024
Thank you for your response, it will be very helpful for my upcoming projects. Additionally, I would like to verify whether the deployment of CNNs on FPGA (PULP) can be facilitated using the DORY tool.