[Pulpissimo]where are the <board_target>.sh ?
#6
Hi,
Pulpissimo is supported. There is no specific file for pulpissimo in pulp-rt because it's not a chip so we don't have any specific information in terms of padframe and so on
For the fpga, we are indeed only supporting genesys2 in the script which is in charge of running a test, but you can still launch the test with classic openocd commands as usual. The runtime does not need to know the fpga, it's compiled the same way whatever the fpga.
Reply


Messages In This Thread
RE: [Pulpissimo]where are the <board_target>.sh ? - by germain_haugou - 12-16-2019, 02:05 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)