09-23-2019, 06:02 AM
Dear magseet, did you manage to fix your issue? I have the same issue. The pad in pad_frame is PU already, both simulation & FPGA show constant sda & scl.
|
I2C on Pulpissimo
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
I2C on Pulpissimo - by magseet - 12-03-2018, 09:41 PM
RE: I2C on Pulpissimo - by kgf - 12-04-2018, 08:58 AM
RE: I2C on Pulpissimo - by magseet - 12-04-2018, 11:11 AM
RE: I2C on Pulpissimo - by kgf - 12-05-2018, 07:52 AM
RE: I2C on Pulpissimo - by kgf - 12-05-2018, 02:11 PM
RE: I2C on Pulpissimo - by magseet - 12-05-2018, 03:33 PM
RE: I2C on Pulpissimo - by gideros - 09-23-2019, 06:02 AM
RE: I2C on Pulpissimo - by gideros - 10-21-2019, 07:01 AM
RE: I2C on Pulpissimo - by kgf - 10-25-2019, 12:33 PM
RE: I2C on Pulpissimo - by bluewww - 11-14-2019, 03:05 AM
|
Users browsing this thread: 1 Guest(s)