Where is the "get started" documentation?
#1
Greetings.

I don't have time to be eloquent, sorry.

Is there some documentation, readme or tutorial on how to use the pulp designs?
Maybe it is common knowledge in the field of digital design (like ./configure make is a common standard in software), but I am a meager noob and student and I spent lots of hours without getting anything to work.

I managed to use modelsim to compile all RI5CY sources necessary to run a simulation of tb_riscv_core, but there was no clock signal and I don't know how to load programs etc.
Maybe I was hasty but I couldn't find proper help in the repo.

Thanks.
Regards Robin.
Reply


Messages In This Thread
Where is the "get started" documentation? - by byllgrim - 01-14-2019, 10:24 AM

Forum Jump: