Pulpissimo L2 memory access via JTAG
#1
Hello,

I am trying to write and read L2 memory via JTAG . According to datasheet memory map it should be in 0x1c000000...0x1c080000. and in soc_bus_defines there is definition
// MASTER PORT TO L2
`define SOC_L2_START_ADDR        32'h1C00_0000
`define SOC_L2_END_ADDR          32'h1FFF_FFFF


However the above parameters are not used anywhere and I can not succesfully write and read to that area. I get always zeros from  any memory address that i have tried.
So where is the memory located actually ? 
I went through the related RTL codes and found local parameter TCDM_START_ADDRESS, which is set to diffrent memory area, and it looked that might be the used area but still the memory access is not working.

As background:
I have succesfylly read and written quite a many peripheral resister, SOC control registers etc, so the JTAG link as such works.
I have implemented Pulpissomo on KIntex FPGA on Genesys board. The xilinx memories seem to be in shape.

Regards, skor
Reply


Messages In This Thread
Pulpissimo L2 memory access via JTAG - by skor - 05-08-2019, 07:41 AM
RE: Pulpissimo L2 memory access via JTAG - by kgf - 05-08-2019, 08:45 AM

Forum Jump: