Help to run Hello Example

[igor.lima]

Hi!

First thanks for replying and sorry about my late reply, i was in vocation

LPLA, thanks for replay!
the simulation was not executed because i already have the FPGA, there are no reason to run the simulation if i already have a tested FPGA, my problem as described is not in FPGA target, but in assembly generated by compiler, for while it doesn't matter what kind of platform i will use to run the pulpissimo, simulation or FPGA will broke anyway because the instructions are wrong, so it is just a compile issue.

meggiman, thanks for reply!

Very useful your information, i follow what you said and still have the same issue, i had installed the pulp-toolchain using;
Installation (Pulp)

Code:

./configure --prefix=/opt/riscv --with-arch=rv32imc --with-cmodel=medlow --enable-multilib
make

I was not able to find a remove tool for toolchain, to remove the newlib install, then install pulp install.

There is a default way to full remove the toolchain?


So what i have done was install the "pulp" install after "newlib"  install, is it ok?

Then i compile the example with
make clean all

After that i run in example
make dis

it give me the same kind of assembly with illegal instructions stuffs...

Best Reggards, Igor