I2C on Pulpissimo
#5
Thanks to you we have identified one issue. The pad cell used in the  

  rtl/pulpissimo/pad_frame.sv

was (mistakenly) a pull down pad and not a pull up pad. This is now fixed. We did not yet try a full application, but a smaller test showed us that tis seemed to be the issue. We will be looking into it, but you could maybe give it a try to see if this solves the issue.
Visit pulp-platform.org and follow us on twitter @pulp_platform
Reply


Messages In This Thread
I2C on Pulpissimo - by magseet - 12-03-2018, 09:41 PM
RE: I2C on Pulpissimo - by kgf - 12-04-2018, 08:58 AM
RE: I2C on Pulpissimo - by magseet - 12-04-2018, 11:11 AM
RE: I2C on Pulpissimo - by kgf - 12-05-2018, 07:52 AM
RE: I2C on Pulpissimo - by kgf - 12-05-2018, 02:11 PM
RE: I2C on Pulpissimo - by magseet - 12-05-2018, 03:33 PM
RE: I2C on Pulpissimo - by gideros - 09-23-2019, 06:02 AM
RE: I2C on Pulpissimo - by gideros - 10-21-2019, 07:01 AM
RE: I2C on Pulpissimo - by kgf - 10-25-2019, 12:33 PM
RE: I2C on Pulpissimo - by bluewww - 11-14-2019, 03:05 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)