PULP Community › PULP's Community forum › PULP General questions v
Pulpissimo bitstream generation.

Linear Mode
Pulpissimo bitstream generation.
naprpo Offline
Junior Member
**
Posts: 7
Threads: 2
Joined: Jun 2019
#7
07-15-2019, 08:59 AM
(07-15-2019, 08:28 AM)AhmedZaky Wrote: Hey,

I am stuck also at that error " openocd: src/target/riscv/riscv.c:2530: riscv_set_current_hartid: Assertion `riscv_hart_enabled(target, hartid)' failed. ", I've read the comments but I couldn't locate that patched openocd that comes with the SDK. May you please elaborate more one this  ?

Thanks !

Hi AhmedZaky,

Did you check the folder pulp-sdk/scripts?

I found the info there.

Regards,
naprpo
Find
Reply


Messages In This Thread
Pulpissimo bitstream generation. - by naprpo - 06-27-2019, 12:43 PM
RE: Pulpissimo bitstream generation. - by gideros - 07-01-2019, 07:36 AM
RE: Pulpissimo bitstream generation. - by naprpo - 07-12-2019, 12:20 PM
RE: Pulpissimo bitstream generation. - by naprpo - 07-15-2019, 11:02 AM
RE: Pulpissimo bitstream generation. - by naprpo - 07-15-2019, 08:59 AM
RE: Pulpissimo bitstream generation. - by gideros - 07-16-2019, 02:22 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)