PULP Community › PULP's Community forum › PULP General questions v
Linux running on the ZYNQ

Linear Mode
Linux running on the ZYNQ
soyedtuhin Offline
Junior Member
**
Posts: 2
Threads: 1
Joined: Nov 2018
#2
11-13-2018, 02:48 PM (This post was last modified: 11-14-2018, 08:34 AM by soyedtuhin.)
(11-09-2018, 01:00 PM)soyedtuhin Wrote: I have fixed the issue by recompiling everything from beginning but before I make the fpga I exported following for riscy core.


Code:
USE_ZERO_RISCY=0
ZERO_RV32M=0

then it worked. I see helloworld printed.
Find
Reply


Messages In This Thread
Linux running on the ZYNQ - by soyedtuhin - 11-09-2018, 01:00 PM
RE: Linux running on the ZYNQ - by soyedtuhin - 11-13-2018, 02:48 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)