configparser module error when installing Pulpissimo SDK

[jmmarostegui]

I have tried to install the Pulpissimo SDK, but without success. I have searched in the Forum for a similar problem, but I couldn't find it. Therefore, I'm posting here the sequence of commands I'm issuing and the final result. Any help will be appreciated.

I'm working on a clean Linux 16.04.06 Install. Following the information available in GitHub, here is the sequence I'm following:

1 - sudo apt install git python3-pip gawk texinfo libgmp-dev libmpfr-dev libmpc-dev swig3.0 libjpeg-dev lsb-core doxygen python-sphinx sox graphicsmagick-libmagick-dev-compat libsdl2-dev libswitch-perl libftdi1-dev cmake scons libsndfile1-dev

2 - sudo pip3 install twisted prettytable pyelftools openpyxl xlsxwriter pyyaml numpy configparser pyvcd

3 - sudo pip3 install configparser

4 - cd /opt

5 - sudo mkdir riscv

6 - cd riscv

7 - git clone https://github.com/pulp-platform/pulp-ri...-toolchain

8 - cd pulp-riscv-gnu-toolchain

9 - git submodule update --init --recursive

10 - sudo apt-get install autoconf automake autotools-dev curl libmpc-dev libmpfr-dev libgmp-dev gawk build-essential bison flex texinfo gperf libtool patchutils bc zlib1g-dev

11 - sudo ./configure --prefix=/opt/riscv --with-arch=rv32imc --with-cmodel=medlow --enable-multilib

12 - make

13 - export PULP_RISCV_GCC_TOOLCHAIN=‘/opt/riscv’

14 - cd /opt/riscv

15 - sudo git clone https://github.com/pulp-platform/pulp-builder.git

16 - cd pulp-builder

17 - source configs/pulpissimo.sh

18 - sudo ./scripts/build-gvsoc

This last command fails with the following error:

...
make: Entering directory '/opt/riscv/pulp-builder/archi'
scons
scons: Reading SConscript files ...
ImportError: No module named configparser:
  File "/opt/riscv/pulp-builder/archi/SConstruct", line 4:
    import pulp_config as plpconfig
  File "/opt/riscv/pulp-builder/install/ws/python/pulp_config.py", line 23:
    import configparser
Makefile:2: recipe for target 'build' failed
make: *** [build] Error 2
make: Leaving directory '/opt/riscv/pulp-builder/archi'

I get exactly the same result if, instead of command 18 i issues the following three commands:

./scripts/clean
./scripts/update-runtime
./scripts/build-runtime

Since module configparser was apparently installed in step 3 I don't know what may be wrong.

Thank you very much in advance for your help.