Hello, in the Pulpissimo's README.md，it says
In the section Compiling Applications for the FPGA Target, it says
Question: When I git clone the pulp-sdk.git and changed directory to pulp-sdk/configs/fpgas/pulpissimo/, I only found the genesys2.sh. Now I am using Digilent Nexys Video Board, but there is no nexys_video.sh . What should I do?
Quote:Supported Boards
At the moment the followin g boards are supported:
Digilent Genesys2
Xilinx ZCU104
Xilinx ZCU102
Digilent Nexys Video
ZedBoard
In the section Compiling Applications for the FPGA Target, it says
Quote:To run or debug applications for the FPGA you need to use a recent version of the PULP-SDK (commit id 3256fe7 or newer.'). Configure the SDK for the FPGA platform by running the following commands within the SDK's root directory:
source configs/pulpissimo.sh
source configs/fpgas/pulpissimo/<board_target>.sh
Question: When I git clone the pulp-sdk.git and changed directory to pulp-sdk/configs/fpgas/pulpissimo/, I only found the genesys2.sh. Now I am using Digilent Nexys Video Board, but there is no nexys_video.sh . What should I do?