Error while updating IPs

[LPLA]

Hello,

yesterday I had an error while executing the ./update-ips command.

Code:

Updating ip 'apb_fll_if'...
Traceback (most recent call last):
 File "./update-ips", line 47, in <module>
   ipdb.update_ips()
 File "ipstools/ipstools/IPDatabase.py", line 525, in update_ips
ValueError: invalid literal for int() with base 10: b'

I don't know why I got this error because I didn't change anything on my system, in fact I didn't even use this particular computer at all in the last few weeks.


What I did was get a fresh PULPissimo installation.
So I cloned from the GitHub and updated the ips.
Everything worked fine and the error was gone.

Currently I am trying to generate the bitstream for the Zedboard.
So when I run make zedboard I get the following error:

Code:

ERROR: [Vivado 12-172] File or Directory '/local/lpla/pulpissimo/fpga/pulpissimo-zedboard/ips/xilinx_clk_mngr/ip/xilinx_clk_mngr.xci' does not exist

I then tried to update the ips again.
But now I get the same error again:

Code:

Updating ip 'apb_fll_if'...
Traceback (most recent call last):
 File "./update-ips", line 47, in <module>
   ipdb.update_ips()
 File "ipstools/ipstools/IPDatabase.py", line 525, in update_ips
ValueError: invalid literal for int() with base 10: b''

I have been trying to generate the bitstream for the Zedboard for a few days now but I run from one error into another.
As mentioned just yesterday I freshly pulled PULPissimo and updated the ips without any problems.
I didn't do pull anything else or manipulate any of the files or scripts.
Still I get the error again. Also it says that my local repo is already up-to-date.

Does anyone have an idea why this keeps happening?
All I'm trying to do is create the bitstream for the Zedboard following all the steps mentioned in the GitHub.

Edit: I just did a fresh install of PULPissimo again and this time it worked. Still it's weird that I got that error twice for no obvious reason. Maybe someone has an idea what happened...

Thank you,
LPLA