Can I remap Pulpissimo pads to connect a camera on Genesys2 fpga board?

[tparng]

Hi,

I want to connect a camera to Pulpissimo's Camera Interface (CPI) on Genesys2 board.  However, most CPI pads are connected to LEDs/buttons/switches on Genesys2 board.  Can I modify the constraints file to remap and connect the CPI signals to the FMC connector so that I can use Digilent FMC Pcam Adapter to connect camera modules?  Any considerations I need to take ?

Thanks,

tparng