Can I remap Pulpissimo pads to connect a camera on Genesys2 fpga board?
#2
That should not be an issue.. AFAIK, CPI is not a very well defined standard, so some tweaking might be necessary to adapt to the specific camera you are using. If you have a good mapping/solution, it would be great if you could make a PR to contribute to the repo.

Cheers,
KGF
Visit pulp-platform.org and follow us on twitter @pulp_platform
Reply


Messages In This Thread
RE: Can I remap Pulpissimo pads to connect a camera on Genesys2 fpga board? - by kgf - 01-07-2023, 02:23 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)