Can I remap Pulpissimo pads to connect a camera on Genesys2 fpga board?
|
Can I remap Pulpissimo pads to connect a camera on Genesys2 fpga board?
|
01-09-2023, 02:02 PM
After studying the details of Digilent FMC Pcam Adapter, I found it uses MIPI CSI-2 interface, not CPI and it needs much more pads for differential signals. Replacing the CPI module in Pulpissimo with a MIPI CSI receiver seems be much more than just a tweaking task. Any suggestions ?
Thanks, tparng |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Can I remap Pulpissimo pads to connect a camera on Genesys2 fpga board? - by tparng - 01-07-2023, 02:11 PM
RE: Can I remap Pulpissimo pads to connect a camera on Genesys2 fpga board? - by kgf - 01-07-2023, 02:23 PM
RE: Can I remap Pulpissimo pads to connect a camera on Genesys2 fpga board? - by tparng - 01-09-2023, 02:02 PM
|
