how to manipulating of GPIOs on Pulpissino platform
#1
Hi,
I would like to do some manipulation of the user and general purchase I/Os of the pianissimo platform, for example to light up a user LED via pressing down a pushbutton.
I found the functions in the sdk runtime doc for configuring the gpio as a bus such as rt_gpio_init and rt_gpio_pin_configure etc, but I did not find any document mentioning the exact address/pin or registers that are corresponding to the LEDs or pushbuttons. I am wondering where to get the detailed info of such so that I can light up a user LED?

Thanks,
Mapletree
Reply


Messages In This Thread
how to manipulating of GPIOs on Pulpissino platform - by mapletree - 09-23-2019, 02:46 PM

Forum Jump: