Tock OS on pulpissimo
#1
I've been looking at porting Tock OS on to the pulp platform and mostly reading through the documentation. I'm fairly new to this whole thing, so I have few questions. According to the TockOS porting guide, I need to define the following in the linker file

Quote: For most developers, it should
 * be sufficient to define {ROM/PROG/RAM}_{ORIGIN/LENGTH} (6 variables, the start and length for each),
 * MPU_MIN_ALIGN (the minimum alignment granularity supported by the MPU) and PAGE_SIZE (the size of a flash page).
 * If undefined, PAGE_SIZE uses the default value of 512 bytes.

Reading through the pulpissimo datasheet, I was unable to find those exact information, so I was wondering, can I use the Data Memory for PROG? and can I use the Boot ROM for ROM? I don't see anything related to MPU mentioned in the datasheet, so is that not supported for pulp platform? 

Are there any other OS that runs on this platform?
Reply


Messages In This Thread
Tock OS on pulpissimo - by cyberbemon - 05-31-2021, 02:28 PM
RE: Tock OS on pulpissimo - by bluewww - 06-01-2021, 11:25 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)