Can I remap Pulpissimo pads to connect a camera on Genesys2 fpga board?
#1
Hi,

I want to connect a camera to Pulpissimo's Camera Interface (CPI) on Genesys2 board.  However, most CPI pads are connected to LEDs/buttons/switches on Genesys2 board.  Can I modify the constraints file to remap and connect the CPI signals to the FMC connector so that I can use Digilent FMC Pcam Adapter to connect camera modules?  Any considerations I need to take ?

Thanks,

tparng
Reply


Messages In This Thread
Can I remap Pulpissimo pads to connect a camera on Genesys2 fpga board? - by tparng - 01-07-2023, 02:11 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)