mno pulp hwloop error
#1
I went through the pulpissimo setup and when i run the hello rt test.

It gives me an error saying the following:

riscv32-unknown-elf-gcc error: unrecognized command line option -mno-pulp-hwloop.

I ran the following to setup the compiler.

Code:
./configure --prefix=/opt/riscv --with-arch=rv32imfcxpulpv3 --with-abi=ilp32 --enable-multilib
make
Reply


Messages In This Thread
mno pulp hwloop error - by Roogadget - 10-25-2024, 04:27 PM
RE: mno pulp hwloop error - by kgf - 10-25-2024, 04:33 PM
RE: mno pulp hwloop error - by Roogadget - 10-25-2024, 06:13 PM
RE: mno pulp hwloop error - by kgf - 10-25-2024, 06:45 PM
RE: mno pulp hwloop error - by Roogadget - 10-25-2024, 07:03 PM
RE: mno pulp hwloop error - by Roogadget - 10-30-2024, 09:16 AM
RE: mno pulp hwloop error - by kgf - 10-30-2024, 09:19 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)