I2C on Pulpissimo
#1
Hi,
I'm trying to use the I2C controller to communicate with my own I2C peripheral. First, I was trying to build the tb by including the I2C EEPROM (I've followed the README instructions). The problem is that, when using the example program for I2C, the RTL simulation gets stuck at the first write operation. Moreover, SDA and SCL signals never toggle during RTL simulation.

Do you have an example program I can use to make I2C work? I guess I need to make some initialization..
Reply


Messages In This Thread
I2C on Pulpissimo - by magseet - 12-03-2018, 09:41 PM
RE: I2C on Pulpissimo - by kgf - 12-04-2018, 08:58 AM
RE: I2C on Pulpissimo - by magseet - 12-04-2018, 11:11 AM
RE: I2C on Pulpissimo - by kgf - 12-05-2018, 07:52 AM
RE: I2C on Pulpissimo - by kgf - 12-05-2018, 02:11 PM
RE: I2C on Pulpissimo - by magseet - 12-05-2018, 03:33 PM
RE: I2C on Pulpissimo - by gideros - 09-23-2019, 06:02 AM
RE: I2C on Pulpissimo - by gideros - 10-21-2019, 07:01 AM
RE: I2C on Pulpissimo - by kgf - 10-25-2019, 12:33 PM
RE: I2C on Pulpissimo - by bluewww - 11-14-2019, 03:05 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)