12-05-2018, 02:11 PM
Thanks to you we have identified one issue. The pad cell used in the
rtl/pulpissimo/pad_frame.sv
was (mistakenly) a pull down pad and not a pull up pad. This is now fixed. We did not yet try a full application, but a smaller test showed us that tis seemed to be the issue. We will be looking into it, but you could maybe give it a try to see if this solves the issue.
rtl/pulpissimo/pad_frame.sv
was (mistakenly) a pull down pad and not a pull up pad. This is now fixed. We did not yet try a full application, but a smaller test showed us that tis seemed to be the issue. We will be looking into it, but you could maybe give it a try to see if this solves the issue.
Visit pulp-platform.org and follow us on twitter @pulp_platform