Sharing data between PULP and HWPE on HERO
#11
(02-06-2019, 07:47 AM)Adi Wrote: How do I do the same thing in PULPissimo? I see that there is no such constant in pulp_soc_defines.sv in PULPissimo. Do I change TCDM_END_ADDRESS in soc_interconnect.sv?

I think that should work, but I am not very familiar with PULPissimo. If it does not work, please open a new thread on this so we can direct the attention of the responsible people there.
Reply


Messages In This Thread
RE: Sharing data between PULP and HWPE on HERO - by akurth - 02-06-2019, 11:34 AM

Forum Jump: