08-09-2019, 02:33 PM
Hello,
I'm trying to develop an application that loads some data from a file that is stored on the host computer. I found an example of doing this in the pulp-rt-examples/bridge/file, so I would like to simulate this in the GVSOC platform and pulp config file, but I'm not sure if I'm doing this in the correct way.
When I start running the example (make all clean run under pulp-rt-examples/bridge/file) I get this message from the console:
Proxy listening on port 37539
So what I do is to start a plpbridge on another terminal like this, which ends after 2 seconds or something like that:
plpbridge --config=pulp@config_file=chips/pulp/pulp.json reqloop --binary=./test
And in the first terminal, I get this new message:
Proxy: Client connected!
The thing is that after that, nothing else happens, the code seems to be frozen and nothing happens. Am I missing something?
Thanks a lot,
Ivan.
I'm trying to develop an application that loads some data from a file that is stored on the host computer. I found an example of doing this in the pulp-rt-examples/bridge/file, so I would like to simulate this in the GVSOC platform and pulp config file, but I'm not sure if I'm doing this in the correct way.
When I start running the example (make all clean run under pulp-rt-examples/bridge/file) I get this message from the console:
Proxy listening on port 37539
So what I do is to start a plpbridge on another terminal like this, which ends after 2 seconds or something like that:
plpbridge --config=pulp@config_file=chips/pulp/pulp.json reqloop --binary=./test
And in the first terminal, I get this new message:
Proxy: Client connected!
The thing is that after that, nothing else happens, the code seems to be frozen and nothing happens. Am I missing something?
Thanks a lot,
Ivan.