Optimized design "vopt_tb" cannot be used by this version
#3
(04-21-2021, 02:41 PM)kgf Wrote: There are a couple of independent problems here.

- It seems like you used vopt (which is one part of compilation process you have done) using a 32bit version and then are trying to start the simulator (vsim) using a 64bit version. At least the error suggests that. This should be on your end, not an issue on the PULP part.

Thanks, that was the issue. I had one too many environment variables that pointed to 2 different versions of modelsim. I changed them to point to the correct version and I can get things to compile.
Reply


Messages In This Thread
RE: Optimized design "vopt_tb" cannot be used by this version - by cyberbemon - 04-26-2021, 07:00 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)