Can I remap Pulpissimo pads to connect a camera on Genesys2 fpga board?
|
Can I remap Pulpissimo pads to connect a camera on Genesys2 fpga board?
|
01-07-2023, 02:23 PM
That should not be an issue.. AFAIK, CPI is not a very well defined standard, so some tweaking might be necessary to adapt to the specific camera you are using. If you have a good mapping/solution, it would be great if you could make a PR to contribute to the repo.
Cheers, KGF
Visit pulp-platform.org and follow us on twitter @pulp_platform
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Can I remap Pulpissimo pads to connect a camera on Genesys2 fpga board? - by tparng - 01-07-2023, 02:11 PM
RE: Can I remap Pulpissimo pads to connect a camera on Genesys2 fpga board? - by kgf - 01-07-2023, 02:23 PM
RE: Can I remap Pulpissimo pads to connect a camera on Genesys2 fpga board? - by tparng - 01-09-2023, 02:02 PM
|
