Pulp - make build
#1
I'm having trouble with the setup of just pulp, i followed the instructions from the website
but when i run make build, i get the following errors.

make[2]: *** [Makefile:87: librbs.so] Error 1
make[2]: Leaving directory '/home/vboxuser/Documents/pulp/rtl/tb/remote_bitbang'
make[1]: *** [Makefile:18: build-deps] Error 2
make[1]: Leaving directory '/home/vboxuser/Documents/pulp/sim'
make: *** [Makefile:124: build] Error 2



I have questasim, ubuntu 22.04 and installed the packages and compilers are instructed.
I've updated my bashrc with the expected exports too.

Resolved, please ignored. It was just an issue of loading the correct config.
Reply
#2
"Actually, I encountered the same issue as you. Could you please let me know if this is caused by a configuration loading error?"
Reply
#3
I had the same problem that you had. Would you kindly inform me if a configuration loading issue is the reason of this?
Reply
#4
It's always the small configuration details that can cause such errors. I've had the same error before.
Reply
#5
(10-25-2024, 07:33 PM)Roogadget Wrote: I'm having trouble with the setup of just pulp, i followed the instructions from the website  Stickman Hook
but when i run make build, i get the following errors. 
make[2]: *** [Makefile:87: librbs.so] Error 1
make[2]: Leaving directory '/home/vboxuser/Documents/pulp/rtl/tb/remote_bitbang'
make[1]: *** [Makefile:18: build-deps] Error 2
make[1]: Leaving directory '/home/vboxuser/Documents/pulp/sim'
make: *** [Makefile:124: build] Error 2
I have questasim, ubuntu 22.04 and installed the packages and compilers are instructed.
I've updated my bashrc with the expected exports too.
Resolved, please ignored. It was just an issue of loading the correct config.

Which version of QuestaSim are you using, and is it properly linked in your path?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)