Question about bitstream generation
#5
(02-23-2021, 02:24 PM)meggiman Wrote: You should call the appropriate make target (check the Makefile in the ips/xilinx_clk_mngr). There is no nexys target there. Use 'make all'.

Thanks for your reply! When I run 'make all' I would receive the following errors:

/pulpissimo-nexys/ips/xilinx_clk_mngr $ make all
../../fpga-settings.mk:33: *** 

No Nexys board revision given. Please use 'make nexys rev=[nexys4|nexys4DDR|nexysA7-100T|nexysA7-50T]'

.  Stop.

That's why I target nexys. Any suggestions would be appreciated. Thanks.
Reply


Messages In This Thread
RE: Question about bitstream generation - by zorrolee777 - 02-23-2021, 08:22 PM

Forum Jump:


Users browsing this thread: 4 Guest(s)