04-15-2019, 09:48 AM
Hello,
Thank You. We got it working by using Genesys2 on board FTDI chip (1.).
But then suddenly it did not work.
Error message:
FATAL ERROR: the command 'reset' has failed with an exception: Failed to initiate cable with error: Could not connect to JTAG device
On Genesys2 there is this chip: https://www.ftdichip.com/Support/Documen...T2232H.pdf
https://github.com/pulp-platform/pulp-de...ted-cables
"Supported cables
2 FTDI cables are supported: --cable=ftdi@olimex and --cable=ftdi@digilent. However the bridge may need few modifications depending on the ftdi chip which is used."
Does this chip which is on Genesys2 board require any special settings or modifications?
Br,
Akim
Thank You. We got it working by using Genesys2 on board FTDI chip (1.).
But then suddenly it did not work.
Error message:
FATAL ERROR: the command 'reset' has failed with an exception: Failed to initiate cable with error: Could not connect to JTAG device
On Genesys2 there is this chip: https://www.ftdichip.com/Support/Documen...T2232H.pdf
https://github.com/pulp-platform/pulp-de...ted-cables
"Supported cables
2 FTDI cables are supported: --cable=ftdi@olimex and --cable=ftdi@digilent. However the bridge may need few modifications depending on the ftdi chip which is used."
Does this chip which is on Genesys2 board require any special settings or modifications?
Br,
Akim