FPGA JTAG-cable and debugger sw

[bluewww]

Trace:

Traceback (most recent call last):
 File "/home/mijkau/Work/debug/pulp-builder/install/ws/bin/plpbridge", line 439, in <module>
   handle_commands(bridge)
 File "/home/mijkau/Work/debug/pulp-builder/install/ws/bin/plpbridge", line 425, in handle_commands
   if commands.get(cmd)[1](bridge) != 0:
 File "/home/mijkau/Work/debug/pulp-builder/install/ws/bin/plpbridge", line 213, in reset
   return bridge.reset()
 File "/home/mijkau/Work/debug/pulp-builder/install/ws/python/bridge/default_debug_bridge.py", line 343, in reset
   self.get_cable().jtag_reset(True)
 File "/home/mijkau/Work/debug/pulp-builder/install/ws/python/bridge/default_debug_bridge.py", line 199, in get_cable
   self.__mount_cable()
 File "/home/mijkau/Work/debug/pulp-builder/install/ws/python/bridge/default_debug_bridge.py", line 184, in __mount_cable
   self.__mount_ctype_cable()
 File "/home/mijkau/Work/debug/pulp-builder/install/ws/python/bridge/default_debug_bridge.py", line 194, in __mount_ctype_cable
   system_config = self.config
 File "/home/mijkau/Work/debug/pulp-builder/install/ws/python/bridge/default_debug_bridge.py", line 85, in __init__
   raise Exception('Failed to initialize cable with error: ' + self.module.bridge_get_error().decode('utf-8'))
Exception: Failed to initialize cable with error: Could not connect to JTAG device

Does this problem still persist or was it a configuration error on your side?